Hello Guest it is March 29, 2024, 08:20:11 AM

Author Topic: Homing direction (can you change it)?  (Read 2399 times)

0 Members and 1 Guest are viewing this topic.

Homing direction (can you change it)?
« on: October 07, 2009, 05:01:03 AM »
I never set up the homing on my mill since once I mounted a vice on the table, it would crash the back of the vise into the machine if it tried to home it.  Been manually setting it up ever time I turn on the machine.  That's getting old and I'm doing alot of the same parts over and over.

Can I change the setup so when I try to home the machine it sends the table towards me (in the negative Y direction)?  X and Z homing isn't a problem.

Or do I need to modify my limit switch?

Thanks

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Homing direction (can you change it)?
« Reply #1 on: October 07, 2009, 05:38:02 AM »
Config menu then Homing and limits and either check or uncheck the Reverse option.
Hood