Hello Guest it is March 29, 2024, 07:32:40 AM

Author Topic: Mach3 talking to Smooth Stepper  (Read 3593 times)

0 Members and 1 Guest are viewing this topic.

Mach3 talking to Smooth Stepper
« on: September 18, 2009, 04:22:58 PM »
I have a mill equipped with Smooth Stepper talking to a Campbell card then ultimately to a Delta VFD. I fired this gem up last nite and the spindle would not work. I then saw that the dir relay and 0-10vdc led would not light when I pressed spindle control. Went back thru the Mach screen and saw nothing that I remembered as being wrong. The step and dir was marked (notPWM), but yet I feel confident that either Mach not talking to SS or ss not taking to Campbell. Would appreciate and chiming in
racear

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Mach3 talking to Smooth Stepper
« Reply #1 on: September 18, 2009, 04:25:42 PM »
Is it set up in the SS plugin?
Hood
Re: Mach3 talking to Smooth Stepper
« Reply #2 on: September 20, 2009, 03:22:00 PM »
Yes it is set up
thanks
racear