Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: racear2865 on September 18, 2009, 04:22:58 PM
-
I have a mill equipped with Smooth Stepper talking to a Campbell card then ultimately to a Delta VFD. I fired this gem up last nite and the spindle would not work. I then saw that the dir relay and 0-10vdc led would not light when I pressed spindle control. Went back thru the Mach screen and saw nothing that I remembered as being wrong. The step and dir was marked (notPWM), but yet I feel confident that either Mach not talking to SS or ss not taking to Campbell. Would appreciate and chiming in
racear
-
Is it set up in the SS plugin?
Hood
-
Yes it is set up
thanks
racear