Hello Guest it is March 29, 2024, 01:29:41 AM

Author Topic: G code needed  (Read 38190 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: G code needed
« Reply #50 on: March 15, 2010, 03:42:19 AM »
Hi Robert,

I had some of the Guinness last night, just to get into practice for the 17th, all I can say is that when it comes to drinking the Irish certainly know how to do it.  ;D

Try this one - It needs to be done with a fine engraving point 30 degrees or finer.
I used a 40 degree on this sample and it lost some of the fine detail on the front wheel. The finished piece will be on brass sheet, mounted on mahogany.

I look forward to seeing your prancing moose, painted Ferrari yellow of course.

Tweakie.
PEACE
Re: G code needed
« Reply #51 on: March 15, 2010, 06:16:35 PM »
Hey tweakie: Hi. I Cut this beauty on a peace of aluminum I had, used a 60* 1/4 inch shaft. what do you think mate? I think it's a beauty.
Got some more?  ;D
Re: G code needed
« Reply #52 on: March 15, 2010, 06:17:43 PM »
ooops. wrong picture:   >:(  So sorry i'll sendit with the next 1
Re: G code needed
« Reply #53 on: March 15, 2010, 06:22:05 PM »
here we go again:

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: G code needed
« Reply #54 on: March 16, 2010, 03:17:44 AM »
Excellent work Robert.
We will make an engraver out of you yet.

Tweakie.
PEACE