Hello Guest it is March 28, 2024, 05:07:40 AM

Author Topic: history errors  (Read 2821 times)

0 Members and 1 Guest are viewing this topic.

history errors
« on: August 31, 2009, 09:37:35 PM »
 I keep getting an error that says    "  Radius to end of arc differs from radius to start of line "
I'm using vectrics Aspire and Vectrics pro 6 and both get the same error is there a setting in Mach 2/3 that might have got changed ?

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: history errors
« Reply #1 on: August 31, 2009, 10:00:43 PM »
IJ mode in general config.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: history errors
« Reply #2 on: August 31, 2009, 11:02:54 PM »
thanks ger21 I'll give it a try tomorrow 
Re: history errors
« Reply #3 on: September 01, 2009, 04:13:25 PM »
Ger21 thanks I changed the setting of the iJ mode and it works great  your a life saver

thanks again