Hello Guest it is September 23, 2023, 02:23:23 PM

Author Topic: referencing home  (Read 2486 times)

0 Members and 1 Guest are viewing this topic.

referencing home
« on: August 21, 2009, 12:31:08 PM »
I just set up my K2 plasma table with CandCNC motors and drives. And I have a basic question about Mach. When you reference an axis to home, is the DRO supposed to zero itself? Or set to whatever offset is entered in config? When I reference my axis nothing changes on the DRO. and I have checked the auto Zero box in Config.   Thanks

Offline Hood

  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: referencing home
« Reply #1 on: August 21, 2009, 01:02:02 PM »
Press the Machine Coords button after referencing and the axis should all reaqd zero. Press it again and you will be back to your work offsets.