Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: JimDean on August 21, 2009, 12:31:08 PM

Title: referencing home
Post by: JimDean on August 21, 2009, 12:31:08 PM

I just set up my K2 plasma table with CandCNC motors and drives. And I have a basic question about Mach. When you reference an axis to home, is the DRO supposed to zero itself? Or set to whatever offset is entered in config? When I reference my axis nothing changes on the DRO. and I have checked the auto Zero box in Config.   Thanks

Title: Re: referencing home
Post by: Hood on August 21, 2009, 01:02:02 PM

Press the Machine Coords button after referencing and the axis should all reaqd zero. Press it again and you will be back to your work offsets.
Hood