Hi all, I posted on the download thread, but figured I would post here also.
I just got a Shuttle pro and am having problems. I've got a licensed version of mach and it has been running my shoptask for over a year. I loaded the shuttle pro plug in, configured a couple buttons, restarted mach and the shuttle will cause the leds to change as if it is working, but all the motors sit and grind with no movement. Tried deactivating the plug in by unchecking it and the same results except the shuttle doesn't do anything, just the normal jog causes the leds to change but no movement. Removed the shuttle dll and restart computer and mach works correctly.
Figured it may be a version issue, so downloaded the latest lockdown of mach and tried again. Tried with the plug in that downloaded with mach, and a couple of the other versions that are on new plug in thread. Same results for all. If the plug in is there, the motors just hum and grind with no real movement. With the dll removed, mach works normally.
Shuttle pro drivers are not installed and when I plugged it into the USB the first time, the pop up saying it was found appeared.
USB port is on the computer, shuttle wire doesn't run near the motor wires, usb port works for other hardware.
any ideas?