Hi,
the reason that your machine cannot go fast is that you've set the maximum speed at 226mm/min which is very slow.
The first and second screen shots you posted show the X and Y axis velocity to be 226mm/min. This is the maximum speed Mach will try to drive
your machine, I think it should be something like 2000mm/min.
When you are cutting you use G1 codes which operate at F********* speeds, where ********* can be up to the maximum for that axis, if you take my
suggestion 2000mm/min. When traversing you use G0 codes which always go at maximum speed, 2000mm/min. When jogging in Cont mode
the machine will move at a percentage of maximum speed.
You need to read the manual, this is basic setup stuff...
5.5.2 Setting the maximum motor speed
Still using the Config>Motor Tuning dialog, as you move the Velocity slider you will see a
graph of velocity against time for a short imaginary move. The axis accelerates, maybe
runs at full speed and then decelerates. Set the velocity to maximum for now. Use the
Acceleration slider to alter the rate of acceleration/deceleration (these are always the same
as each other)
Go to the Artsoft site and download the manual for Mach3 operation and read it, then read it again...and again.
Craig