Hello Guest it is March 28, 2024, 06:42:37 PM

Author Topic: 4 axis  (Read 3232 times)

0 Members and 1 Guest are viewing this topic.

4 axis
« on: July 20, 2009, 03:25:35 PM »
Hello

I understand that when i want to make one rotation of the fourth axis the g code will be g1 A360 f.002 .But what if i want to make more than one rotation of the A axis.

Thank you for your time

Marcel Beaudry

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: 4 axis
« Reply #1 on: July 20, 2009, 03:41:08 PM »
Hi, Marcel

Use g1 A720 f.002, There are setting's in Config, General Config page you can change the way it act's.

Chip
Re: 4 axis
« Reply #2 on: July 20, 2009, 03:47:50 PM »
Hy Chip

So if i want to make 2 turns i just type the total amount of degres needed like 720

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: 4 axis
« Reply #3 on: July 20, 2009, 03:57:45 PM »
Hi, Marcel

Yes, If you set the rol-over to un-checked then you'll see the total amount commanded, You need to play with the setting's to see the different functions.

Chip
Re: 4 axis
« Reply #4 on: July 20, 2009, 04:04:33 PM »
THANK YOU again Chip


Marcel