Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: marcel beaudry on July 20, 2009, 03:25:35 PM
-
Hello
I understand that when i want to make one rotation of the fourth axis the g code will be g1 A360 f.002 .But what if i want to make more than one rotation of the A axis.
Thank you for your time
Marcel Beaudry
-
Hi, Marcel
Use g1 A720 f.002, There are setting's in Config, General Config page you can change the way it act's.
Chip
-
Hy Chip
So if i want to make 2 turns i just type the total amount of degres needed like 720
-
Hi, Marcel
Yes, If you set the rol-over to un-checked then you'll see the total amount commanded, You need to play with the setting's to see the different functions.
Chip
-
THANK YOU again Chip
Marcel