I posted the following message in the g-code section of this forum and got no answer. Did I do something wrong?
I have been able to adjust my three axis and they all work fine and smooth while I jog the motors. Now I think it’s time to set the home / limits on Mach3. This is my first build of a CNC router with a table size of 48”x26”, travel of each axis is approx X=24”, Y=38”, Z=9”.
I would have like to have a simple g-code to move the axis for testing. Like I would like to jog lets say the X axis to the home position and the run a g-code to say “move X axis from 0” to +24” and then the g-code will terminate. Then I will repeat this for the Y and Z axis. I would prefer not to have a g-code that will test all 3 axis at the same time. One axis at a time is much better for me
Is this the right way to do it?
Obviously I have no experience at all with mach3 or g-code but I’m learning as I go along.
Nicolas