Hello Guest it is March 19, 2024, 01:25:21 AM

Author Topic: mach3 not saving my x and z  (Read 2854 times)

0 Members and 1 Guest are viewing this topic.

mach3 not saving my x and z
« on: August 14, 2006, 09:57:28 PM »
when i pick up my x and z and machine a part when im finished and i close mach3 down it says save tools and fixture and i say yes. but when i restart it again it looses my numbers and i have to recalibrate x and z again. any help here would be greatly appreciated.
Re: mach3 not saving my x and z
« Reply #1 on: August 14, 2006, 10:05:42 PM »
There is a check box under the State "copy G54 from G59 P 253 on start up" or something like that... optinal offset save and so on is there as well
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com