Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: catch22 on August 14, 2006, 09:57:28 PM
-
when i pick up my x and z and machine a part when im finished and i close mach3 down it says save tools and fixture and i say yes. but when i restart it again it looses my numbers and i have to recalibrate x and z again. any help here would be greatly appreciated.
-
There is a check box under the State "copy G54 from G59 P 253 on start up" or something like that... optinal offset save and so on is there as well