Hello
Guest
it is
April 29, 2024, 01:07:48 AM
Guest
Login
Register
Menu
Home
Help
Search
Calendar
Members
Members
View the memberlist
Search For Members
Login
Register
YouTube
Machsupport Forum
/
G-Code, CAD, and CAM
/
G-Code, CAD, and CAM discussions
/
Radius to end of arc issue
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Radius to end of arc issue (Read 4217 times)
0 Members and 1 Guest are viewing this topic.
Tdfox60
1
Radius to end of arc issue
«
on:
May 18, 2009, 10:52:28 AM »
Newbie here. I am setting up to run my table top router for the first time using Mach 3. I loaded my first G-Code and I am not able to get the program to run. I am getting a message that reads "Radius to end of Arc differs from radius to startline 23"
Can someone please help this newbie out?
Logged
ger21
6,295
Re: Radius to end of arc issue
«
Reply #1 on:
May 18, 2009, 10:54:08 AM »
Change the IJ mode in General Config.
Logged
Gerry
2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
electraflyit
3
Re: Radius to end of arc issue
«
Reply #2 on:
August 21, 2009, 08:45:01 AM »
I'm having the same problem.
I don't understand what mode to change in config.
Eddie
Logged
Chip
2,055
Gainesville Florida USA
Re: Radius to end of arc issue
«
Reply #3 on:
August 21, 2009, 02:42:04 PM »
Hi, Eddie
This is probilly what you need to change or put a G90.1 or G91.1 in the top of your G code file.
Hope this helps, Chip
Logged
RICH
7,427
Re: Radius to end of arc issue
«
Reply #4 on:
August 21, 2009, 05:58:59 PM »
Try taking a look at the ACR Motion wirte up in Members Docs. It's for a Lathe but it covers a lot on arc's info.
RICH
Logged
Print
Pages:
1
Go Up
« previous
next »