Hi, is the developing of Mach IV stopped and replace with G100 plug in for Mach3?
What is the status of that plug in right now? Is it possible to run a machine based on a Grex
with homing, limit, probing and jogging and so on?

//Roger

Hi I am not the devinitive sorce on all that is mach 3+ plug in but i am running it and can give a couple of answers.

Probing, no
home, limits, yes
jog, yes

it will do everything that mach 4 will do. and seems to be more stable. As far as i have heard mach 4 is not fgoing to get any more code work, everything is going to be mach3 and the g100 plug in

Chad
 

Probeing is working and IV is no more

Thanks for your answers,
I have got the Grex for a while now, but I didn't want to rebuild my working
mill until the Grex was fully supported. Maybe it's time to make the switch.

Roger

I would hold off for the new firmware update.. it should be any month now.

OK thanks, looking forward to that.

Roger