Hello Guest it is December 02, 2024, 02:21:13 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Cutter radius comp problem  (Read 13993 times)

0 Members and 1 Guest are viewing this topic.

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Cutter radius comp problem
« Reply #10 on: January 04, 2006, 03:17:35 PM »
Sorry that was my poor atampt at telling you that if you put nothing Mach will put in the D Val for the T number that is loaded.

Sorry again
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Pages: « 1 2   Go Up
« previous next »