Hello Guest it is April 25, 2024, 05:33:45 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Galil And Gcode  (Read 2846 times)

0 Members and 1 Guest are viewing this topic.

Offline Cncman2nv

*
  • 90 90
    • View Profile
Galil And Gcode
« on: March 27, 2009, 03:04:15 PM »
I am running a Galil dmc controller and when i run gcode from mastercam with a Fanuc generic post  the axis steps per unit settings seem to be diffrent than when mdi line godes any ides !!!
Logged
Adam

Offline Graham Waterworth

*
  • *
  • 2,673 2,673
  • Yorkshire Dales, England
    • View Profile
Re: Galil And Gcode
« Reply #1 on: March 28, 2009, 08:21:39 PM »
My idea is you can not change the step rate with g-code.

Graham
Logged
Without engineers the world stops
Pages: 1   Go Up
« previous next »