Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Cncman2nv on March 27, 2009, 03:04:15 PM

Title: Galil And Gcode
Post by: Cncman2nv on March 27, 2009, 03:04:15 PM

I am running a Galil dmc controller and when i run gcode from mastercam with a Fanuc generic post  the axis steps per unit settings seem to be diffrent than when mdi line godes any ides !!!

Title: Re: Galil And Gcode
Post by: Graham Waterworth on March 28, 2009, 08:21:39 PM

My idea is you can not change the step rate with g-code.

Graham