Hood,
Yup...nice mill, puny head.
The "Z" screw is being a PITA.
The only ones Rockford has to fit are semi-precision rolled w/.005" to .015" backlash. There is no room for their preloaded double nut type.
Thomson has just what I need...$1020.00 plus end prep if I want it.
Nook will let me know tomorrow.
eBay.....not much right now and most is in Asia.
I'm contemplating going w/new oversize balls..(wife agrees
), and just let it run a little rough for a while. $12 on eBay.
I'll keep looking though.
The cracked yoke is probably what caused the problem. It was cracked and hinging up and down causing a hell of a bind on the nut and screw.
Oh well.....not quite the price of a new mill in this one....YET ! lol
See ya,
RC