Hello Guest it is March 28, 2024, 03:28:13 PM

Author Topic: Status of Galil Integration w/Mach  (Read 4267 times)

0 Members and 1 Guest are viewing this topic.

Status of Galil Integration w/Mach
« on: February 14, 2009, 04:49:28 PM »
Maybe this is the wrong forum, but I am interested in using Galil servo drives.   What is the official status of the Galil drivers/plugins?   Is anyone using dual encoder inputs (servo) on a Galil/Mach3 setup?  What do you give up, if anything, by going with Galil hardware?  Tnx in advance.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Status of Galil Integration w/Mach
« Reply #1 on: February 14, 2009, 05:05:58 PM »
Dont know anything about the Galil but will ask around.
Hood
Re: Status of Galil Integration w/Mach
« Reply #2 on: February 14, 2009, 05:15:38 PM »
There is a new version of the plugin that Steve and Kenny have done... I have not seen it but I have heard only very good reports.. I hope one of them can pipe up and tell you what the status is..


Thanks
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Status of Galil Integration w/Mach
« Reply #3 on: February 19, 2009, 10:52:48 AM »
Brian-
   Thanks.   How can I get Steve or Kenny to respond to this?
Re: Status of Galil Integration w/Mach
« Reply #4 on: February 23, 2009, 09:39:18 AM »
Brian-
   No luck with replys - any suggestions?
Re: Status of Galil Integration w/Mach
« Reply #5 on: February 23, 2009, 01:29:53 PM »
There is a section for third party hardware, the galil status is talked about here,

http://www.machsupport.com/forum/index.php?topic=2156.new;topicseen#new

Hope that helps,
Cutmore