Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bruce Griffing on February 14, 2009, 04:49:28 PM
-
Maybe this is the wrong forum, but I am interested in using Galil servo drives. What is the official status of the Galil drivers/plugins? Is anyone using dual encoder inputs (servo) on a Galil/Mach3 setup? What do you give up, if anything, by going with Galil hardware? Tnx in advance.
-
Dont know anything about the Galil but will ask around.
Hood
-
There is a new version of the plugin that Steve and Kenny have done... I have not seen it but I have heard only very good reports.. I hope one of them can pipe up and tell you what the status is..
Thanks
Brian
-
Brian-
Thanks. How can I get Steve or Kenny to respond to this?
-
Brian-
No luck with replys - any suggestions?
-
There is a section for third party hardware, the galil status is talked about here,
http://www.machsupport.com/forum/index.php?topic=2156.new;topicseen#new
Hope that helps,
Cutmore