Hello Guest it is May 25, 2025, 07:59:38 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: start position  (Read 7152 times)

0 Members and 1 Guest are viewing this topic.

Offline mkink

*
  • 4 4
start position
« on: August 04, 2008, 09:42:52 AM »
Is it possible to give my mill a general start position after ref??
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: start position
« Reply #1 on: August 04, 2008, 09:47:40 AM »
Yoiu can set a G28 position on the homing and limits page (from Config tab) you can then either call G28 from the MDI line or you could add a line to your Ref All button to do the G28 after you have referenced your machine.
Hood
Logged
Pages: 1   Go Up
« previous next »