Hello Guest it is May 25, 2025, 01:27:28 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mach 3 rapid clearance question  (Read 11345 times)

0 Members and 1 Guest are viewing this topic.

Offline prcfab

*
  • 1 1
Mach 3 rapid clearance question
« on: March 31, 2021, 01:08:59 PM »
Wondering why my rapid clearance dose not always work . It is correct in the G code Z of 1.00 and it always works when i dry run with torch turned off but with torch turned on it drags on the sheet even tho the g code is correct . Any ideas ?
Logged

Offline TPS

*
  • 2,578 2,578
Re: Mach 3 rapid clearance question
« Reply #1 on: April 03, 2021, 11:37:04 AM »
maybe THC is enabled?
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Pages: 1   Go Up
« previous next »