Hello Guest it is May 29, 2025, 11:14:33 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: CamBam to Mach3  (Read 6162 times)

0 Members and 1 Guest are viewing this topic.

Offline Windy1

*
  • 3 3
CamBam to Mach3
« on: February 15, 2015, 01:12:00 PM »
When I generate gcode in CamBam the files are larger when loaded into Mach3.

Thanks in advance for any help!!
Gayle
Logged

Offline BR549

*
  • 6,965 6,965
Re: CamBam to Mach3
« Reply #1 on: February 15, 2015, 03:53:16 PM »
Maybe draw the part smaller  ;D  sorry could not help it.

Make SURE your drawing units (inch, MM) are the same for both Programs.

Check the output Gcode for a G20(inch) or G21(mm) reference .

(;-) TP
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: CamBam to Mach3
« Reply #2 on: February 15, 2015, 04:21:53 PM »
Also make sure you are using the correct post processor.

If your like me, all my files are realy small ......only do one line at a time ???.....just jesting with ya! :) ;) :D ;D

RICH
Logged

Offline Windy1

*
  • 3 3
Re: CamBam to Mach3
« Reply #3 on: February 15, 2015, 05:23:31 PM »
 :D
Logged
Pages: 1   Go Up
« previous next »