Machsupport Forum
G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: Windy1 on February 15, 2015, 01:12:00 PM
-
When I generate gcode in CamBam the files are larger when loaded into Mach3.
Thanks in advance for any help!!
Gayle
-
Maybe draw the part smaller ;D sorry could not help it.
Make SURE your drawing units (inch, MM) are the same for both Programs.
Check the output Gcode for a G20(inch) or G21(mm) reference .
(;-) TP
-
Also make sure you are using the correct post processor.
If your like me, all my files are realy small ......only do one line at a time ???.....just jesting with ya! :) ;) :D ;D
RICH
-
:D