Hello Guest it is May 06, 2025, 01:34:45 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Wiring THC into Gecko board and plasma cutter  (Read 6000 times)

0 Members and 1 Guest are viewing this topic.

Offline jjmueller

*
  • 27 27
Wiring THC into Gecko board and plasma cutter
« on: May 21, 2013, 10:54:30 PM »
Ok, so I am including photos, I need to wirer my Proma THC into a Gecko G540 2-axis drive into my Hypertherm powermax 85.

Can someone help me with the wiring.

Including photos of the Proma and Gecko Drive board.

Thanks
Jerry

Logged

Offline jjmueller

*
  • 27 27
Re: Wiring THC into Gecko board and plasma cutter
« Reply #1 on: May 21, 2013, 10:55:39 PM »
Sorry its a 4-axis not 2.  Typo
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Wiring THC into Gecko board and plasma cutter
« Reply #2 on: May 25, 2013, 08:22:40 PM »
What exactly are you needing the help on and do you have a link to the manual for the proma?
Hood
Logged

Offline jjmueller

*
  • 27 27
Re: Wiring THC into Gecko board and plasma cutter
« Reply #3 on: June 02, 2013, 08:21:35 PM »
OK! I have most everything working now except that mach will not start the plasma, I have the relay wired into the g540 at output 1 pin 17 and I can push the torch on the screen in mach and it works but just doesn't on a part. Maybe this is a problem in the Gcode since I only have the demo sheetcam right now.  Can someone look at the code a tell me if this is so. just did a simple square to try the machine out
Logged
Pages: 1   Go Up
« previous next »