Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jjmueller on May 21, 2013, 10:54:30 PM
-
Ok, so I am including photos, I need to wirer my Proma THC into a Gecko G540 2-axis drive into my Hypertherm powermax 85.
Can someone help me with the wiring.
Including photos of the Proma and Gecko Drive board.
Thanks
Jerry
-
Sorry its a 4-axis not 2. Typo
-
What exactly are you needing the help on and do you have a link to the manual for the proma?
Hood
-
OK! I have most everything working now except that mach will not start the plasma, I have the relay wired into the g540 at output 1 pin 17 and I can push the torch on the screen in mach and it works but just doesn't on a part. Maybe this is a problem in the Gcode since I only have the demo sheetcam right now. Can someone look at the code a tell me if this is so. just did a simple square to try the machine out