Hello Guest it is April 30, 2025, 11:04:03 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mach3 and Vcarve6 CNC3040  (Read 4768 times)

0 Members and 1 Guest are viewing this topic.

Offline SirFinland

*
  • 55 55
Mach3 and Vcarve6 CNC3040
« on: December 01, 2013, 11:55:47 AM »
Hi,


Is there any "right" settings for Vcarve 6 so it will work okay with Mach3 and a cnc3040?

Settings for Feed Rate and Plunge Rate and so on.....
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: Mach3 and Vcarve6 CNC3040
« Reply #1 on: December 01, 2013, 12:05:18 PM »
Feed rates are dictated by the material your cutting, the tool your using, and the rpm the spindle is turning. It also has a little to do with trial and error to get the best results.
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline SirFinland

*
  • 55 55
Re: Mach3 and Vcarve6 CNC3040
« Reply #2 on: December 01, 2013, 12:09:14 PM »
Thanks!

I have some problems to get the spindle http://www.youtube.com/watch?v=57xY94SnlCQ
Logged

Offline Tweakie.CNC

*
  • *
  • 9,284 9,284
  • Super Kitty
Re: Mach3 and Vcarve6 CNC3040
« Reply #3 on: December 03, 2013, 03:43:09 AM »
From your video it appears that your gantry is not parallel with your table. The following diagram may help.

Tweakie.
Logged
PEACE
Pages: 1   Go Up
« previous next »