Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: SirFinland on December 01, 2013, 11:55:47 AM
-
Hi,
Is there any "right" settings for Vcarve 6 so it will work okay with Mach3 and a cnc3040?
Settings for Feed Rate and Plunge Rate and so on.....
-
Feed rates are dictated by the material your cutting, the tool your using, and the rpm the spindle is turning. It also has a little to do with trial and error to get the best results.
-
Thanks!
I have some problems to get the spindle http://www.youtube.com/watch?v=57xY94SnlCQ
-
From your video it appears that your gantry is not parallel with your table. The following diagram may help.
Tweakie.