Hello Guest it is May 24, 2025, 05:58:03 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: axis direction  (Read 7054 times)

0 Members and 1 Guest are viewing this topic.

Offline kurtzhaven

*
  • 1 1
axis direction
« on: May 11, 2009, 08:27:22 PM »
Hopefully this is a simple question.  How do I switch my axis direction.  I would like to switch z- to z+.  It seems like it should be in the the xml but I can not find it.

Thanks!
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: axis direction
« Reply #1 on: May 11, 2009, 08:32:12 PM »
Homing/Limits screen, check "Reversed"
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline nanobrain3000

*
  • 2 2
Re: axis direction
« Reply #2 on: May 11, 2009, 10:47:46 PM »
simply invert the axis under "motor output" settings... or you can change your hotkey (Config>System HotKeys) but the 2nd step will not change how your cnc will run under the same g code.
Logged

Offline Chip

*
  • *
  • 2,055 2,055
  • Gainesville Florida USA
Re: axis direction
« Reply #3 on: May 12, 2009, 03:51:28 PM »
Hi, Kurt

You should use Config, Homing & Limits screen "Reversed" Column), Using Motor Output's can cause Issues with some Axis Control Board's.

Chip
Logged
Pages: 1   Go Up
« previous next »