Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kurtzhaven on May 11, 2009, 08:27:22 PM
-
Hopefully this is a simple question. How do I switch my axis direction. I would like to switch z- to z+. It seems like it should be in the the xml but I can not find it.
Thanks!
-
Homing/Limits screen, check "Reversed"
-
simply invert the axis under "motor output" settings... or you can change your hotkey (Config>System HotKeys) but the 2nd step will not change how your cnc will run under the same g code.
-
Hi, Kurt
You should use Config, Homing & Limits screen "Reversed" Column), Using Motor Output's can cause Issues with some Axis Control Board's.
Chip