Hello Guest it is February 05, 2026, 12:24:50 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: More clean and optimize  (Read 8251 times)

0 Members and 1 Guest are viewing this topic.

Offline N4NV

*
  • 398 398
More clean and optimize
« on: February 20, 2009, 03:34:12 PM »
In the attached file (a cribbage board) there are 367 holes.  Any circle that is .375" is a hole for a peg.  I can't seem to get LazyCam to clean up and optimize the drilling of all the holes, I just jumps all over.  Any suggestions?

Thanks

Vince
Logged

Offline Overloaded

*
  • *
  • 4,923 4,923
Re: More clean and optimize
« Reply #1 on: February 20, 2009, 04:08:24 PM »
Hi Vince,
I dissabled all except the HOLE Layer, then select Drill RAD Circles, then enter max. radius and it looks OK.
HTH,
RC
Logged

Offline N4NV

*
  • 398 398
Re: More clean and optimize
« Reply #2 on: February 20, 2009, 08:26:54 PM »
OK, I understand now, when I had the other layers open it was tying to do a little of everything.

Thanks

Vince
Logged

Offline N4NV

*
  • 398 398
Re: More clean and optimize
« Reply #3 on: February 22, 2009, 01:13:07 PM »
I found my problem, I was using an older version of LazyCam.  After I downloaded the most recent version, I could get the drilled holes to layout in a decent order.

Thanks

Vince
Logged

Offline Overloaded

*
  • *
  • 4,923 4,923
Re: More clean and optimize
« Reply #4 on: February 22, 2009, 08:00:41 PM »
COOL!
Logged
Pages: 1   Go Up
« previous next »