Machsupport Forum
G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: N4NV on February 20, 2009, 04:34:12 PM
-
In the attached file (a cribbage board) there are 367 holes. Any circle that is .375" is a hole for a peg. I can't seem to get LazyCam to clean up and optimize the drilling of all the holes, I just jumps all over. Any suggestions?
Thanks
Vince
-
Hi Vince,
I dissabled all except the HOLE Layer, then select Drill RAD Circles, then enter max. radius and it looks OK.
HTH,
RC
-
OK, I understand now, when I had the other layers open it was tying to do a little of everything.
Thanks
Vince
-
I found my problem, I was using an older version of LazyCam. After I downloaded the most recent version, I could get the drilled holes to layout in a decent order.
Thanks
Vince
-
COOL!