61
General Mach Discussion / computer problem
« on: July 26, 2006, 05:19:39 PM »
hi all,
i am using mach 3 on a lathe with a clone computer and a campbell breakout board, and everything is working fine. now my hard disk is going to die very soon, some times it starts some times not. so i decided to replace it with another computer i already have wich is an hp vectra. i configure everything the same and follow the steps in the optimization procedure, but there is nothing coming out of the parralel port. is there any know issues regarding hp computers and mach 3? i ran the driver test and it works.
i am using mach 3 on a lathe with a clone computer and a campbell breakout board, and everything is working fine. now my hard disk is going to die very soon, some times it starts some times not. so i decided to replace it with another computer i already have wich is an hp vectra. i configure everything the same and follow the steps in the optimization procedure, but there is nothing coming out of the parralel port. is there any know issues regarding hp computers and mach 3? i ran the driver test and it works.