281
General Mach Discussion / G95 Lathe problem
« on: January 12, 2010, 07:21:20 AM »
OK this has been happening for the last three releases i am using Ver 3.042.035
This is with a smooth stepper
When i program my feed rates with G95 at first it does not conform to the speed selected there is some sort of buffer that after a few moves this buffer will empty then the fed will suddenly start feeding at the correct rate.
Anyone have similar problems and got a fix ?
Phil
This is with a smooth stepper
When i program my feed rates with G95 at first it does not conform to the speed selected there is some sort of buffer that after a few moves this buffer will empty then the fed will suddenly start feeding at the correct rate.
Anyone have similar problems and got a fix ?
Phil