Messages

21

General Mach Discussion / Re: Tool Path display

« on: September 30, 2010, 06:38:51 PM »

OK I have attached a config pdf witch has the current I/O connections for the DSPMC controller showing the mapping. I have also attached the correct manual for the DSPMC,
Thank you again for your help

22

General Mach Discussion / Re: Tool Path display

« on: September 30, 2010, 06:15:43 PM »

Yes I attached the wrong manual, I am currently geeting all the configuration info confired. I will send when I have all the data correct
Sorry for the confusion, FIY this is an either net connection

23

General Mach Discussion / Re: Tool Path display

« on: September 30, 2010, 05:40:10 PM »

The maping is on pages 32 thru 37 covers each section

24

General Mach Discussion / Re: Tool Path display

« on: September 30, 2010, 05:25:11 PM »

Based on my interpretation of the configuration guide I believe it is configured correctly, I have attached the info for review.
The problem only seams to be when we change fixture offsets during any given program. If we just use G54 things run fine.

25

General Mach Discussion / Re: Tool Path display

« on: September 30, 2010, 01:46:40 PM »

Here are the files you requested
Thank you for reviewing

26

General Mach Discussion / Re: Tool Path display

« on: September 29, 2010, 05:04:47 PM »

Email to what adress

27

General Mach Discussion / Re: Tool Path display

« on: September 29, 2010, 04:12:27 PM »

No G51's

28

General Mach Discussion / Re: Tool Path display

« on: September 29, 2010, 03:48:19 PM »

All axis jog in the correct direction, The problem seames to be with fixture offsets G55,G56,G57 the program uses G54 Thru G57 and G54 displays correctly all others are reversed.
From MDI you can type G55 x10.0 y-10.0 and the display is correct, the same move executed from program is reversed

29

General Mach Discussion / Tool Path display

« on: September 29, 2010, 12:28:54 PM »

Tool path displays correct when program is loaded or regenerated, however when program is actually ran the sines for X and Y reversed and causes soft limit warnings and displays tool path accordingly
system configured using DSPMC plug-in by Vidal Systems
Any thoughts