Messages

1

General Mach Discussion / Re: Scripter Compile Errors

« on: December 01, 2011, 04:40:40 PM »

Gerry,

I am running version 3.042.040

2

General Mach Discussion / Re: Scripter Compile Errors

« on: December 01, 2011, 11:49:50 AM »

Has anyone seen this error??
I get periodic scriptor compile errors in spindle .mis and when tapping in:M4.mis
Any ideas
Problem continues

3

General Mach Discussion / Re: Scripter Compile Errors

« on: December 01, 2011, 11:05:15 AM »

Still getting Scripter Compile Error in M3.mis
Machine ran fine all day no problems, started this morning agin, checked files and everything looks normal but spindle does not turn,Requries mach reboot to fix
Any Ideas??

4

General Mach Discussion / Re: Scripter Compile Errors

« on: November 30, 2011, 11:37:01 AM »

Thanks that fixed the problem

5

General Mach Discussion / Scripter Compile Errors

« on: November 29, 2011, 06:55:03 PM »

Has anyone seen this error??
I get periodic scriptor compile errors in spindle .mis and when tapping in:M4.mis
Any ideas

6

General Mach Discussion / Re: Mach did again!

« on: October 07, 2010, 01:44:06 PM »

Dennis

I found that the problem was directly related to the tool change I changed the config to Ignore Tool Change from Stop Spindal wait for cycle start and added  befor the next tool M0 and every thing is fine now
I also found that if you don't make tool changes ther is no problem
There is another thread under plugins DSPMC that has moor info

7

dspMC/IP Motion Controller / Re: Fixture Offsets

« on: October 07, 2010, 01:13:08 PM »

Thank every one for your input

Here is the scenario
Did nothing to Y axis configuration
changed config to Ignore Tool Change
Added M1 to stop program between tool changes (every thing runs perfect)
Changed M1 to M0 to eliminate the possibility of optional stop being turned off and crashing the tool (same results)
Pryor to those changes
I fount that if a axis moved in the wrong direction you can open the Save fixture page select X save Y save then restart the tool and every will run correctly
Will advise if any thin changes

8

dspMC/IP Motion Controller / Re: Fixture Offsets

« on: October 06, 2010, 08:10:25 PM »

Sure it can't hurt
I will post results in the morning

9

dspMC/IP Motion Controller / Re: Fixture Offsets

« on: October 06, 2010, 08:03:34 PM »

Tool change is set to
Stop spindle wait for cycle start
We have to change to manually
I will change X in the morning just to see if it has any impact

10

dspMC/IP Motion Controller / Re: Fixture Offsets

« on: October 06, 2010, 07:24:20 PM »

Here is the screen shot