Messages

1

Building or Buying a Wood routing table.. Beginnners guide.. / Re: CNC 5040 z-axis problem

« on: January 03, 2021, 08:09:00 AM »

Next question is about cuting depth, it is perfect 1/2 from set. If i set up cut 18mm plywood machine cut only 9mm. if i set up 36mm machine cut 18mm plywood without problem.
 I need change z- axis steps increase in Motor tuning and setup?

2

Building or Buying a Wood routing table.. Beginnners guide.. / Re: CNC 5040 z-axis problem

« on: January 02, 2021, 08:28:55 AM »

Big thanks, one big problem is reslove, key word was close mach 3 and restart again.

3

Building or Buying a Wood routing table.. Beginnners guide.. / Re: CNC 5040 z-axis problem

« on: January 02, 2021, 07:49:03 AM »

we test all other axis and all move oposite diretions, where to change these to reverse?

4

Building or Buying a Wood routing table.. Beginnners guide.. / Re: CNC 5040 z-axis problem

« on: January 02, 2021, 07:44:01 AM »

we work with remote, and not tested.
After Your text we test and answer is no.
pagedown z- machine goes up not down, and z+ machine goes down, not up.

5

Building or Buying a Wood routing table.. Beginnners guide.. / Re: CNC 5040 z-axis problem

« on: January 02, 2021, 06:32:24 AM »

we try, but not work...

6

Building or Buying a Wood routing table.. Beginnners guide.. / Re: CNC 5040 z-axis problem

« on: December 31, 2020, 06:42:19 AM »

ok,
thanks next week try this.

7

Building or Buying a Wood routing table.. Beginnners guide.. / CNC 5040 z-axis problem

« on: December 30, 2020, 02:14:27 PM »

Hello,
I am new with cnc, we buy from china to cut some materials. Machine x.y axis work without problem. But problem is about z-axis.
z-axis think oposite than can be.
Machine when start cut, moves down and  then cut on up not down, and after program is finish return to down.
We change in artcam material thickess and from buttom  to top, but nothing change.
we change home limits from negative to positive and oposite for z-axis ( soft max 1 and soft min -255) but nothing change
Machine z-axis negative values is on up (sealing) and positive values on floor. But why machine moves always on negative values (sealing).
How to configure mach 3, to make the machine think oposite?
Controller is XHC with wifi controler.