1
General Mach Discussion / Re: Getting a Handle on Tool Height
« on: October 09, 2020, 05:40:22 PM »
I am struggling with this as well but it's part of the Macro set from the Probe Wizard set and incorporated into a screen set from Physics Anonymous well suited to touchscreens that I like quite a bit actually but there is something fundamentally missing here as it seems as though the Z Probing and the Tool setting are working with the same code so I am thinking more along the lines of a fundamental flaw here.
Screen set is http://www.physanon.com/pa-mach-3-screen-set/:
Again the goal remains the same though and I think many of us feel the same so it has to be there I am thinking
I want to set a part....XYZ probe it to locate and then insert a tool and have that tool tip know where the Z height I just established in the probe cycle.
So far the XYZ probing has worked wonderfully but here I am at a wall.
Screen set is http://www.physanon.com/pa-mach-3-screen-set/:
Again the goal remains the same though and I think many of us feel the same so it has to be there I am thinking
I want to set a part....XYZ probe it to locate and then insert a tool and have that tool tip know where the Z height I just established in the probe cycle.
So far the XYZ probing has worked wonderfully but here I am at a wall.