Messages

1

General Mach Discussion / Re: New to routing need help with letters

« on: September 14, 2009, 10:11:56 AM »

cutting the actual letters,  the tool paths all look right with good corners but when cut the corners get rounded.. this is my first day at work since I made the post so I'm gonna try some of the settings sam suggested

2

General Mach Discussion / New to routing need help with letters

« on: September 11, 2009, 06:02:45 PM »

Hi,

I'm very new to routing but have experience running a vinyl cutter.

We've got our router up and running and have cut out a few words using lazycam/mach3

The issue were having is the router is rounding parts of letters that should be a 90 degree corner,  such as the corners on the top of an upper case L.

I'm not sure where to start with this problem if anyone has any suggestions I would greatly appreciate it.

Thanks,
Tyler