1
General Mach Discussion / New to routing need help with letters
« on: September 11, 2009, 06:02:45 PM »
Hi,
I'm very new to routing but have experience running a vinyl cutter.
We've got our router up and running and have cut out a few words using lazycam/mach3
The issue were having is the router is rounding parts of letters that should be a 90 degree corner, such as the corners on the top of an upper case L.
I'm not sure where to start with this problem if anyone has any suggestions I would greatly appreciate it.
Thanks,
Tyler
I'm very new to routing but have experience running a vinyl cutter.
We've got our router up and running and have cut out a few words using lazycam/mach3
The issue were having is the router is rounding parts of letters that should be a 90 degree corner, such as the corners on the top of an upper case L.
I'm not sure where to start with this problem if anyone has any suggestions I would greatly appreciate it.
Thanks,
Tyler