1
General Mach Discussion / Re: Spindle button disables stepper motors (Laser engraving on a 4 axis mill)
« on: February 01, 2018, 01:45:56 PM »
Solved!
I had to activate (green tick) the Dir LowActive on the Spindle line in Motor Outputs.
On my TB6600 card I have this config:
Under Motor Output I have Spindle on Step Pin N. 16, Dir Pin N. 1, Dir LowActive on Green, Step Low Active on Red, Step Port on 1, Dir Port on 1.
Under Output Signals I have Output N.1 on Green, Port N. 1, Pin Number 14 Active Low on Red
Under Spindle Setup I have PWM Base Freq. at 500 and Min PWM at 0%.
This is with the Chinese 2W laser that sells for about 100 dollars on Ebay.
I had to activate (green tick) the Dir LowActive on the Spindle line in Motor Outputs.
On my TB6600 card I have this config:
Under Motor Output I have Spindle on Step Pin N. 16, Dir Pin N. 1, Dir LowActive on Green, Step Low Active on Red, Step Port on 1, Dir Port on 1.
Under Output Signals I have Output N.1 on Green, Port N. 1, Pin Number 14 Active Low on Red
Under Spindle Setup I have PWM Base Freq. at 500 and Min PWM at 0%.
This is with the Chinese 2W laser that sells for about 100 dollars on Ebay.