Hello guys, I finally received my repaired lathe.
It's been a long wait but now it is finally, mechanically, ok.

Problem is the screenset or the macro pump provided by the company who made the conversion sucks: the first referencing doesn't work most of the times.
Sometimes it pushes the tool changer wheel out and not back in, sometimes it doesn't go towards the limit switches, sometimes it halts for no reason...
After a successful referencing sometimes it doesn't react to M6T0x0x tool change command. Sometimes it does it without loving to the tool change X/Z position.
Sometimes it looses some parameters...
It's a total mess and this German company who made the screen set and macro pump doesn't help.

I was wondering if any of you had something for a 2 axis lathe with the A axis for the tool changer. The lathe has limit switches, two servo motors and a stepper for the A axis.

Please help!


Inviato dal mio iPhone utilizzando Tapatalk