The velocity in motor tuning is in degrees/min, so the A velocity should be much higher than the velocity of your other axis.
In Config > Toolpath, check "Use Radius for feedrate".
On the Settings page, enter the Rotation Radius for your part. If you are setting Z zero to the center of your stock, enter .001.
Thanks for the reply.
When I home all my axis the A axis turns a lot faster than when I run G code so i know the indexer will turn a lot faster. Currently the Velovity is set to 799 and acceleration is 400. where exactly is the setting where i put in .001 ? I cannot seem to find it. can you post a screenshot if possible
also check out the sample g code i posted below and tell me if it is setting a speed in the code.