Sorry guys, but that's not it either. That's OemButton 110 which is already on the screen. Maybe I need to rephrase my question and explain what I want to do better.
In the "General Config" dialog, in the section for "Program End, M30, or Rewind" there is a check box for "Turn Off Spindle" which will disable turning off the spindle at a program end, M30, or rewind. I want to have a button and led to toggle that checkmark in the same manner that the CV distance button and led on the settings page toggles the checkmark for CV distance tolerance in the general config dialog. I don't want to turn the router off, I want to keep it on.
The reason for this is that I'm making a wizard for a certain thing that I do a lot of. While doing this, I want the spindle (in my case a router) to keep running while I swap out a blank and cycle start after a rewind instead of it turning off and on, off and on,.....
I'm just being lazy, and don't want to open the general config dialog each time I need to change this setting. I would also like to be able to "Set" it in a macro or wizard.
I hope this explains what I want to do a bit better.
Thanks