I have a store bought plasma table or should say eBay bought and it has a legal mach3 with it but I did buy a different machine with a bootleg of mach3, I am wondering if I could still use the good copy on my other machines, I am building a larger plasma and also in the process of building a 3d printer and setting my mill and lathe cnc...am I aloud to use the one copy on all or did I take a loss on the bad copy? I did pay extra for it not knowing it was a bad copy
Thanks
Ed
Hi Ed, the official line is...
Without a license, Mach3 will operate in Demo mode. While in Demo mode, the software has the following limitations:
Mill & Plasma: 500 line gcode limit (10,000,000 limit after licensing)
Turn: 50 line gcode limit (10,000,000 limit after licensing)
Kernel Frequency locked at 25kHz (only applicable if using the parallel port driver)
Set Next Line function disabled
Run From Here function disabled
Turn: Threading disabled
Plasma: THC functions disabled
Non-commercial users (aka hobbyists) are permitted to use one Mach license for as many machines as they require. For commercial users (anybody who uses the software to generate profit), we require a separate license purchase for each machine. Mach1, Mach2, and Mach3 may all be used on one computer, but only one version of each will co-exist on a single computer.
A license is only required on the computer actually running a machine. If a computer not connected to a machine is used to test code, please use Mach3 in Simulation mode – it will remove the 500 line limit. Simulation mode can be accessed by uninstalling (or not installing) the Parallel Port Driver. The Add-ons for Mill will only work with a licensed copy of Mach3 as this software is an Add-on, and not a stand-alone product.
Hard Copies (a disk) of the downloadable content are available directly from a 3rd party.
Tweakie.