Messages

371

Mach4 General Discussion / Re: scr list

« on: March 28, 2019, 05:56:01 PM »

Craig,

I saw that but was hoping there was a more complete list.
I realize not many things need the scr but as far as I can see at least some do.

Thanks again,
Bill

372

Mach4 General Discussion / scr list

« on: March 28, 2019, 05:36:11 PM »

I am unable to find a list of the scr calls that can be made in Mach4.
Does anyone know where one is?

Thanks,
Bill

373

Mach4 General Discussion / Re: input signals

« on: March 25, 2019, 02:50:28 PM »

Craig,

I know I sound crazy but now it works.
The only thing I can think of is maybe I did not exit Mach so a new Lua.mcc could be written.
I am very sorry for taking up your time on this.

Bill

374

Mach4 General Discussion / Re: input signals

« on: March 25, 2019, 02:28:12 PM »

Craig,

I give it a shot.

Bill

375

Mach4 General Discussion / Re: input signals

« on: March 25, 2019, 01:51:51 PM »

Craig,

Only as a homing switch.

Bill

376

Mach4 General Discussion / Re: input signals

« on: March 22, 2019, 05:59:40 PM »

Craig,

Normally I would agree with you.
But the switch works fine for a homing switch.

Bill

377

Mach4 General Discussion / Re: input signals

« on: March 22, 2019, 04:59:05 PM »

Craig,

It does not make any difference.

For some reason it always enters the If-Then loop

Bill

378

Mach4 General Discussion / Re: Is there a Gcode command to reference all axis home?

« on: March 22, 2019, 03:30:45 PM »

My only problem with the G28.1 is the speed is very slow.
I can not find how to change the speed.

379

Mach4 General Discussion / Re: input signals

« on: March 22, 2019, 03:28:58 PM »

Craig,

Yes I have and it does not matter if the switch is active or not.
It enters the If-Then loop.
Trying to read as much on how signals word as I can I saw something about needing to put something in the screen load.
Is that maybe what I am missing?

Bill

380

Mach4 General Discussion / Re: Is there a Gcode command to reference all axis home?

« on: March 22, 2019, 09:33:17 AM »

I am using the
G91 G28.1 X 0.00 Y 0.00
G90
in M4 and it works great.

Bill