481
General Mach Discussion / s curve control board
« on: January 19, 2011, 05:24:02 PM »
I need a control board that does s curves.
I am running 2 x axis servos. (Currently get same step and direction input), 1 y axis servo, 1 z axis servo, 1 rotary atc servo and spindle speed control.
Need some suggestions from anyone.
Thanks, Bill
I am running 2 x axis servos. (Currently get same step and direction input), 1 y axis servo, 1 z axis servo, 1 rotary atc servo and spindle speed control.
Need some suggestions from anyone.
Thanks, Bill