1
Mach3 under Vista / Re: another ref all home problem
« on: April 26, 2017, 04:44:01 AM »
Was directed to the drop down menu of the NcUSBpod in the Plug Ins menu. A bit counter-intuitive for me I was stuck in the homing and limits box. Which is where it would logically be. But it looks as though the detection and backing off from the limit switch is looked after by the USB to parallel software. You can dial up the amount and direction of back off once the switch is detected.
I was about to give up on the hardware/software the came with the 6040 kit from a Noname brand in China and go for a UC100 and Gecko 540. I presume the plug in software for the UC100 will be similar and that's where you'd go to set up the homing switch direction and back off? The UC100 and Gecko 540 is the standard with the best product support is it?
I was about to give up on the hardware/software the came with the 6040 kit from a Noname brand in China and go for a UC100 and Gecko 540. I presume the plug in software for the UC100 will be similar and that's where you'd go to set up the homing switch direction and back off? The UC100 and Gecko 540 is the standard with the best product support is it?